None

Generic DPAK with all three leads. XYZ is set up for altium. X and Y centered about the body of the part, the Z is at the center of the body and at the BOTTOM of the metal tab. Drops into Altium with no changes needed.

None

Gerneric TO-220 designed with Altium in mind. XYZ zero point is at the CENTER of the CENTER pin where it contacts the top of the pcb at the center pin''s hard stop tab. Which is where it needs to be to be able to drop it into altium with no modifications needed. Leads are trimmed to 5mm since this TO-220 is for PCB assembly rendering.

Non fourni(e)

Fairchild

Fairchild FDA24N50. Renders nicely. XYZ center is center of center pin at point that leads flare out. Will drop directly into Alitum with no problems. TO-3PN power MOSFET package.

TI

Non fourni(e)

The case of the transistor KT315 and KT361. The interval between the terminals is 2.5 mm. The length of the terminals is 3mm. Mounting on the board in the holes. Installation at an angle.

The case of the transistor KT315 and KT361. The interval between the terminals is 2.5 mm. The length of the terminals is 2mm. Mounting on the board in the holes. The installation is vertical.

The case of the transistor KT315 and KT361. The interval between the terminals is 2.5 mm. The length of the terminals is 4mm. Mounting on the board in the holes. The installation is vertical.

The case of the transistor KT315 and KT361. The interval between the terminals is 2.5 mm. The length of the terminals is 6mm. Mounting on the board in the holes. The installation is vertical.

Non fourni(e)