Hooked cams for quarter-turn latches, locks and handles. With projection for housings with external limitation of rotation, and without projection for housings with internal limitation of rotation.

MATERIAL:
Steel, zinc plated.

SolidComponents^TM

2- and 4-point cams for rods-systems. Supplied with E-clips.


MATERIAL:
Steel, zinc plated or stainless steel (304).

SolidComponents^TM

Roller cam for three point latching systems with rods. Can remotely operate additional roller cams from a single handle or quarter-turn. Supplied with E-clips.

MATERIAL:
Cam: Steel, passivated.
Shaft and e-clip: Steel, zinc plated.
Roller: Glass fibre reinforced polyamide (PA6), black.

SolidComponents^TM

Cam without projection, with integrated inside handle. For use together with non-locking products and housings with internal limitation of rotation.


MATERIAL:
Steel, zinc plated, or stainless steel (304).

SolidComponents^TM

Three-point cams for use with housings with external limitation of rotation. Stroke: 20 mm. Supplied with e-clips.


* Straight cam

C = Housing length.
H = Outside face to engagement point of cam.
L = 45 mm.
Other lengths and versions available on request.

Rods: Page 2-540, 2-541 and 2-545.

MATERIAL:
Steel, zinc plated or stainless steel (304).

SolidComponents^TM

Three-point cams for use with housings with external limitation of rotation. Stroke: 20 mm. Supplied with e-clips.


* Straight cam

A shows the projection.
C = Housing length.
H = Outside face to engagement point of cam.
L = 45 mm.
Other lengths and versions available on request.

Rods: Page 2-540, 2-541 and 2-545.

MATERIAL:
Steel, zinc plated or stainless steel (304).

SolidComponents^TM

Single-point cams for use with housings with internal limitation of rotation.


* Straight cam

C = Housing length.
H = Outside face to engagement point of cam.
L = 45 mm.
Other lengths and versions available on request.

MATERIAL:
Steel, zinc plated or stainless steel (304).

SolidComponents^TM

Single-point cams for use with housings with external limitation of rotation.


* Straight cam

A shows the projection.
C = Housing length.
H = Outside face to engagement point of cam.
L = 45 mm.
Other lengths and versions available on request.

MATERIAL:
Steel, zinc plated or stainless steel (304) or acid-proof stainless steel (316).

SolidComponents^TM

For use of quarter-turn latch with Combi cut-out, in circular holes, for mounting in wood and glass fibre etc.


MATERIAL:
Zinc die-cast, zinc plated or black coated.

SolidComponents^TM

Spacer nut for installing latches in insulated or laminated doors. The nut is used in combination with housing of corresponding length.


The nut is supplied in two versions:

X: The threaded area located at the flange-end (see drawing). Use on long housings to speed up mounting.

Y: The threaded part located at the open end (see drawing). Use on thick doors, insulated doors or similar.

MATERIAL:
Zinc die-cast,

SolidComponents^TM