Non fourni(e)

Non fourni(e)

Non fourni(e)

basic mount for drill motor

Can be fabricated from 3cm thick plate steel then turned square on your lathe if you do not have a mill or a surface grinder

RT angle adapter for lathe compound and motor

These adapter collets fit inside of a tube like honed DOM to allow the tubing to be fully machined on the end next to the power head of a lathe without the need to re chuck, great for machining extra-long tubes, I advise making one for each ID. I still have the first one that I ever made over 30 years ago and it is still in good condition. Simple to make with minimal equipment or experience, I have used steel, cast iron, brass, and aluminum, even made one out of wood

These adapter collets fit inside of a tube like honed DOM to allow the tubing to be fully machined on the end next to the power head of a lathe without the need to re chuck, great for machining extra-long tubes, I advise making one for each ID. I still have the first one that I ever made over 30 years ago and it is still in good condition. Simple to make with minimal equipment or experience, I have used steel, cast iron, brass, and aluminum, even made one out of wood

These adapter collets fit inside of a tube like honed DOM to allow the tubing to be fully machined on the end next to the power head of a lathe without the need to re chuck, great for machining extra-long tubes, I advise making one for each ID. I still have the first one that I ever made over 30 years ago and it is still in good condition. Simple to make with minimal equipment or experience, I have used steel, cast iron, brass, and aluminum, even made one out of wood

These adapter collets fit inside of a tube like honed DOM to allow the tubing to be fully machined on the end next to the power head of a lathe without the need to re chuck, great for machining extra-long tubes, I advise making one for each ID. I still have the first one that I ever made over 30 years ago and it is still in good condition. Simple to make with minimal equipment or experience, I have used steel, cast iron, brass, and aluminum, even made one out of wood